Panasonic KXTCD320FX Provozní pokyny stáhnout pdf (Strana 40)

SMS (Short Message Service)

40

Sending a message

Writing and sending a new

message

1

Press $ (middle soft key).

2 Select X, then press ,.

3 Select “Create”, then press ,.

L If “^Use Last Text?” is displayed,

you can use the text from the last

message you created by pressing

{e}.

4 Enter the message (page 43), then

press ,.

5 Enter the destination phone number (20

digits max.), then press ,.

L To send the message to a party saved

in the handset phonebook, press

U, select the handset phonebook

entry, then press , 2 times.

L To send the message to a party logged

in the caller list, press {e} or {v}

repeatedly to select the party, then

press , 2 times.

L To send the message to a phone

number logged in the redial list, press

q repeatedly to select the phone

number, then press , 2 times.

6 To save the message, select “Yes”,

then press ,.

L To send the message without saving it,

select “No”, then press ,.

7 To send the message, select “Send”,

then press ,.

L To cancel sending, press {ih}.

Note:

L This unit supports SMS messages of up to

612 characters, however, the maximum

number of characters you can send or

receive may be limited by your SMS

service provider. Consult your SMS

service provider for details.

L If your message contains over 160

characters, the message is a long

message and j is displayed. Your

service provider may treat long messages

differently from other messages. Consult

your service provider for details.

L “Invalid Number” is displayed if you

try to send a message to a phone number

saved in the handset phonebook, caller

list, or redial list that is over 20 digits long.

L When sending a message, “Sending

Message” is displayed momentarily, then

“Transferring Message” is

displayed.

L If your phone is connected to a PBX, store

the PBX line access number (page 42).

Sending a saved message

1

Press $ (middle soft key).

2 Select X, then press ,.

3 Select “Send List”, then press ,.

4 To read a saved message, press {e} or

{v} repeatedly to select the message,

then press ,.

L Messages are displayed in

chronological order and by destination

phone number.

5 To send the message, press $,

select “Send”, then press ,.

6 Press and hold {C/T} to erase all

numbers, then continue from step 5,

“Writing and sending a new message”,

page 40.

Editing and sending a saved

message

1

Press $ (middle soft key).

2 Select X, then press ,.

3 Select “Send List”, then press ,.

4 Press {e} or {v} repeatedly to select

the message, then press ,.

TCD320FX(e).book Page 40 Tuesday, January 18, 2005 1:25 PM

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Komentáře k této Příručce

Žádné komentáře