Panasonic WV-SC588 Instalační příručka stáhnout pdf (Strana 17)

Installations/Connections

Before installation, prepare the following

There are 4 methods to install the camera to a ceiling or wall as described below. Prepare the required devices and cables

for each installation method before starting the installation.

Use the camera mount bracket (accessory).

 • Procure4screws(M4)tosecurethecameramountbracket(accessory).

 • Selectscrewsaccordingtothematerialoftheceilingthatthecamerawillbemountedto.

 • Theminimumrequiredpull-outcapacityofasinglescrewis196N{44lbf}ormore.

 • Whenmountingthecameraonaconcreteceiling,useanAYplugbolt(M4)forsecuring.

(Recommended tightening torque: 1.6 N·m {1.18 lbf·ft})

The area of the ceiling that the camera will be installed to must be sufficiently reinforced, or the optional ceiling mount

bracket for the camera (WV-Q105, weight approx. 0.15 kg {0.33 lbs}) must be used.

 • Whenusingtheceilingmountbracket(WV-Q105),prepare2anchorbolts(M10)tosecurethebrackettoaroofspace

(including 1 for securing the safety wire).

 • Theminimumrequiredpull-outcapacityofasinglescreworanchorboltis5timesormoreofthetotalweightofthe

camera and all of its parts.

 • Existinganchorboltscanbeusedtosecurethesafetywiretoaceiling.Ifexistinganchorboltsareused,theremaynot

be enough supplied nuts to be used with all the anchor bolts. In this case, procure the required nuts separately.

The area of the ceiling that the camera will be installed to must be sufficiently reinforced, or the optional ceiling embedding

bracket for the camera (WV-Q126A, weight approx. 1.2 kg {2.65 lbs}) must be used.

 • Whenusingtheceilingembeddingbracket(WV-Q126A),prepare2anchorbolts(M10)tosecurethebrackettoaroof

space (including 1 for securing the safety wire).

 • Theminimumrequiredpull-outcapacityofasinglescreworanchorboltis5timesormoreofthetotalweightofthe

camera and all of its parts.

 • Existinganchorboltscanbeusedtosecurethesafetywiretoaceiling.Ifexistinganchorboltsareused,theremaynot

be enough supplied nuts to be used with all the anchor bolts. In this case, procure the required nuts separately.

Use the wall mount bracket (WV-Q119, weight approx. 0.65 kg {1.43 lbs}).

 • Procure4screws(M4)tosecurethewallmountbracket(WV-Q119)tothewall.

 • Selectscrewsaccordingtothematerialofthewallthatthecamerawillbemountedto.

 • Theminimumrequiredpull-outcapacityofasinglescreworanchorboltis5timesormoreofthetotalweightofthe

camera and all of its parts.

When installing the camera using the ceiling mount bracket, the ceiling embedding bracket, or the wall mount bracket,

refer to the instructions included with those optional accessories.

Caution:

 • AREADILYACCESSIBLEDISCONNECTDEVICESHALLBEINCORPORATEDTOTHEEQUIPMENTPOWEREDBY

12 V DC POWER SUPPLY.

 • FORULLISTEDMODEL(S),ONLYCONNECT12VDCCLASS2POWERSUPPLY(UL1310/CSA223)orLIMITED

POWER SOURCE (IEC/EN/UL/CSA 60950-1).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Žádné komentáře

Panasonic WV-SC588 Instalační příručka Strana 17