
6
How to use
Auto OFF/ON button
POWER (Green)
TIMER (Orange)
POWERFUL (Orange)
QUIET (Orange)
AUTO
AIR SWING (Orange)
Use when remote control is misplaced or a malfunction occurs.
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release
to use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release
to use in forced HEAT mode.
• Press the button again to turn off.
Control Panel
POWER (Green)
TIMER (Orange)
POWERFUL (Orange)
QUIET (Orange)
AUTO
AIR SWING (Orange)
OPE
N
C
LOSE
CLOSE
OPEN
PO
WER
TI
MER
A
I
R
S
W
I
N
G
O
FF/O
N
MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The POWER
indicator blinks during this operation.
COOL - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
POWERFUL/
QUIET
To switch between
powerful & quiet
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
Single
• This operation stops automatically
after 20 minutes.
Multi
• Press the button again or turn OFF the
unit to stop this operation.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Can be activated in all modes and can be
cancelled by pressing the respective button again.
Remote control
receiver
MODE
POWERFUL/
QUIET
TEMP
OFF/ON
TIMER
SET
CANCEL
ON
OFF
1
2
3
FAN SPEED
SET CHECK CLOCK RESET
AC
RC
AIR SWING
FAN
SPEED
AIR
SWING
AUTO
HEAT
COOL
DRY
FF/
ET
AN
E
FF
HE
L
C
Remote control
display
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
Single
Single split system
Multi
Multi split system
F569176-SS0113-0_1EN.indd 6F569176-SS0113-0_1EN.indd 6 17/04/2013 11:15:3917/04/2013 11:15:39
Process BlackProcess Black
Komentáře k této Příručce