Panasonic S12NKUA Instalační manuál stáhnout pdf

10. Installation Instruction

10.1 S9NKUA S12NKUA

10.1.1 Select the Best Location

10.1.1.1 Indoor Unit

• Do not install the unit in excessive oil fume area

such as kitchen, workshop and etc.

• There should not be any heat source or steam

near the unit.

• There should not be any obstacles blocking the air

circulation.

• A place where air circulation in the room is good.

• A place where drainage can be easily done.

• A place where noise prevention is taken into

consideration.

• Do not install the unit near the door way.

• Ensure the spaces indicated by arrows from the

wall, ceiling, fence or other obstacles.

• Recommended installation height for indoor unit

shall be at least 8.2 ft.

10.1.1.2 Outdoor Unit

• If an awning is built over the unit to prevent direct

sunlight or rain, be careful that heat radiation from

the condenser is not obstructed.

• There should not be any animal or plant which

could be affected by hot air discharged.

• Keep the spaces indicated by arrows from wall,

ceiling, fence or other obstacles.

• Do not place any obstacles which may cause a

short circuit of the discharged air.

• If piping length is over the [piping length for

additional gas], additional refrigerant should be

added as shown in the table.

Example: For S9NKUA

If the unit is installed at 32.8 ft distance, the quantity of

additional refrigerant should be 1.64 oz .... (32.8 - 24.6)

ft x 0.2 oz/ft = 1.64 oz.

10.1.2 Indoor/Outdoor Unit Installation

Diagram

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - 10. Installation Instruction

19 10. Installation Instruction 10.1 S9NKUA S12NKUA 10.1.1 Select the Best Location 10.1.1.1 Indoor Unit • Do not install the unit in excessive oi

Strany 2 - Install a Sleeve of Piping

20 10.1.3 Indoor Unit 10.1.3.1 How to Fix Installation Plate The mounting wall shall be strong and solid enough to prevent if from the vibration.

Strany 3

21 10.1.3.3 Indoor Unit Installation 10.1.3.4 For the right rear piping 10.1.3.5 For the right bottom piping 10.1.3.6 For the embedded piping

Strany 4

22 10.1.3.7 Connect the Cable to the Indoor Unit 1. The inside and outside connection cable can be connected without removing the front grille. 2

Strany 5

23 10.1.3.8 Wire Stripping and connecting requirement 10.1.3.9 Cutting and flaring the piping 1 Please cut using pipe cutter and then remove the

Strany 6

24 10.1.4 Outdoor Unit 10.1.4.1 Install the Outdoor Unit • After selecting the best location, start installation to Indoor/Outdoor Unit Installation

Strany 7 - with a torque wrench

25 10.1.4.3 Evacuation of the equipment WHEN INSTALLATION AN AIR CONDITIONER, BE SURE TO EVACUATE THE AIR INSIDE THE INDOOR UNIT AND PIPES in the fol

Strany 8 - 10.1.4.5 Piping Insulation

26 9. Secure the wire onto the control board with the holder (clamper). 10. After completing wiring connections, reattach the control board cover (

Další dokumenty pro Split-systém klimatizace Panasonic S12NKUA

Zobrazit dokument Panasonic S12NKUA Datový list

Panasonic S12NKUA Datový list (2 stránky)

Zobrazit dokument Panasonic S12NKUA Servisní příručka

Panasonic S12NKUA Servisní příručka (69 stránky)

Zobrazit dokument Panasonic S12NKUA Instalační manuál

Panasonic S12NKUA Instalační manuál (1 stránky)

Komentáře k této Příručce

Žádné komentáře

Panasonic S12NKUA Instalační manuál

Procházejte online nebo si stáhněte Instalační manuál pro Split-systém klimatizace Panasonic S12NKUA. Panasonic S12NKUA Installation Manual Uživatelská příručka

Shrnutí obsahu

Další dokumenty pro Split-systém klimatizace Panasonic S12NKUA

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace Panasonic S12NKUA