Panasonic 470 Uživatelský manuál stáhnout pdf (Strana 21)

Port mirroring 21

Note: The screen data displayed at the bottom of the screen changes

to show the new currently active port mirroring conﬁguration after you

press Enter.

The Monitoring Mode ﬁeld [ Address A - > Address B ] indicates that all

trafﬁc transmitted by address A to address B is monitored by the StackProbe

attached to Monitor Port 23.

Note: When you enter MAC addresses in this screen, they are also

displayed in the MAC Address Table screen EAPOL.

Figure 5

Port Mirroring Conﬁguration address-based screen example

Port mirroring conﬁguration rules

The following conﬁguration rules apply to any port mirroring conﬁguration:

•

You cannot conﬁgure a monitor port as a trunk member or IGMP

member.

•

A monitor port cannot be used for normal switch functions.

•

When you conﬁgure a port as a monitor port, the port is automatically

disabled from participating in the spanning tree. When you reconﬁgure

the port as a standard switch port (no longer a monitor port), the port is

enabled for spanning tree participation.

•

When you create a port-based port mirroring conﬁguration, be sure

that the monitor port and both of the mirrored ports, port X and port Y,

have the same conﬁguration. Use the VLAN Conﬁguration screen to

conﬁgure the VLAN EAPOL.

Nortel Ethernet Switch 460/470

Conﬁguration — System Monitoring

NN47210-503 01.01 Standard

3.7 22 February 2007

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 131 132

Žádné komentáře

Panasonic 470 Uživatelský manuál Strana 21