Panasonic 470 Uživatelský manuál stáhnout pdf (Strana 32)

32 Chapter 2 Conﬁguring network monitoring using CLI

Table 5 "show logging command parameters and variables" (page 32)

describes the parameters and variables for show logging command.

Table 5

show logging command parameters and variables

Parameters and

variables

Description

config

Displays configuration log messages. (This command

parameter is only available with the Ethernet Switch

470-24T.)

critical

Displays critical log messages.

serious

Displays serious log messages.

informational

Displays informational log messages.

Figure 8 "show logging sort-reverse command output" (page 32) shows the

output of the show logging sort-reverse command.

Figure 8

show logging sort-reverse command output

logging

The logging command conﬁgures the system settings for the system

event log of the Ethernet Switch 470-24T. The syntax for the logging

command is:

logging [enable | disable]

[level critical | serious | informational]

[nv-level critical | serious | informational | none]

The logging command is in the conﬁg command mode.

Nortel Ethernet Switch 460/470

Conﬁguration — System Monitoring

NN47210-503 01.01 Standard

3.7 22 February 2007

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 131 132

Žádné komentáře

Panasonic 470 Uživatelský manuál Strana 32