Panasonic WV-ASC970 Provozní pokyny Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 79
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
29
Note:
• "analogcamera"standsforPanasonicanalogcameras.
• "DVR"standsforPanasonicDigitalDiskRecorder/NetworkDiskRecorder.
• Intheredundantsystem,setbothMainandBackupWV-ASC970Servers'IPAddressestothealarmnotification
destination IP Address field of the network device.
• TheCapacityWarning,RAIDDownandThermalarealsoincludedinDVRError.Forexample,ifbothCapacity
Warning and DVR Error are assigned to different alarms and then the Capacity Warning occurs, both alarms are
triggered.
● System Controller WV-CU950 Setup
To add system controllers to the system in Ethernet communication, add an entry to the system controller database
through the admin console. You need to assign a controller ID for each controller, and enter the Ethernet address
from the bottom of each controller.
Note:
• RefertotheAdminConsoleUser'sGuidefordetails.
The MODE and CONTROLLER No. on WV-CU950 rear panel should be set as shown below.
CONTROLLER No.
Maintain the switch
setting as "1".
WV-CU
950
MODE
MODE
1 2 3 4 5 6 7 8
OFF
ON
Set as shown below.
0
9
8
7
6
5
4
3
2
1
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 78 79

Komentáře k této Příručce

Žádné komentáře