Panasonic WV-ASC970 Provozní pokyny Strana 59

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 79
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 58
59
STATE: Indicates video loss changes.
OK: Video loss is recovered.
LS: Video level is below normal and in sync.
VL: Video level is below normal and out of
sync.
HL: Video level is above normal and out of
sync.
TYPE: Place where the video loss occurs.
S: Video crosspoint input (Not supported)
C: Camera control input
DATE/TIME: Date and time when the video loss state
changes.
4. Todisplaythenextpage,pressthe+button.
Todisplaythepreviouspage,pressthe–button.
Note:
• Todisplaythefirstpageoftable,pressthe+but-
ton while holding down the SHIFT button.
• Todisplaythelastpageoftable,pressthe–button
while holding down the SHIFT button.
5. To exit the VIDEO LOSS HISTORY table, perform
either of the following.
• Selectacamera.(Refertop.39Camera
Selection.)
• PresstheMON(ESC)button.
• PresstheEXITbutton.
Note:
• ThisfeatureisavailableinonlyWJ-SX650or
WJ-SX850 because of OSD limitation.
■
Area Change
Note:
• The following function is available only if the
assignments of monitor surveillance areas has
been established through admin console. (Refer to
theAdminConsoleUser'sGuide.)
1. Display "Area No" menu. (Refer to Step 1 and 2 of
p. 53 To Recall Menu Functions.)
Area No:1 012
Set
2. Select an area number by pressing the numeric
buttons.
Note:
• Ifyouhaveselectedanareanotassignedthrough
the admin console, operations will become
unavailable. In this case, log out, and then log into
the system again. (Refer to p. 38 Login and
Logout.)
3. Press the F1 button. The area will be changed.
■
Operator ID
You can check your operator ID as follows.
Display "Ope ID" menu. (Refer to Step 1 and 2 of p. 53
To Recall Menu Functions.)
Your operator ID will be displayed on the LCD.
■
Controller ID
You can check your System Controller ID as follows.
Display "Cnt ID" menu. (Refer to Step 1 and 2 of p. 53
To Recall Menu Functions.)
Your System Controller ID will be displayed on the
LCD.
■
System Version
You can check the system version of CPU as follows.
Display "Ver" menu. (Refer to Step 1 and 2 of p. 53 To
Recall Menu Functions.)
The system version of CPU will be displayed on the
LCD.
Area No:9 012
Set
Ope ID :100 013
Cnt ID :001 014
Ver: 5.0.0.0 015
Zobrazit stránku 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 78 79

Komentáře k této Příručce

Žádné komentáře