Panasonic WJ-ND400 Průvodce nastavením Strana 60

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 110
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 59
60
1 Click the [Server] button.
2 Click the [Mail] tab.
The "Mail" page will be displayed.
3 Configure each setting item.
Refer to "Setup items" mentioned below.
4 Click the [Set] button.
Mail
Configure the settings relating to the alarm mail and the warning mail.
Attach alarm image
Select "On" or "Off" (default) to determine whether or
not to attach an image recorded at an event occurrence
to an e-mail to be sent.
Note:
• Whentheimagecompressionmethodofthecam-
era in the location where an event occurred is
"MPEG-4", the image will not be attached.
• Evenwhen"On"isselected,theimagewillnotbe
attached when "Off" is selected for the recording
rate of the event recording.
SMTP server address
Enter an IP address or a name of the SMTP server to
be used to send e-mails.
Enter up to 255 alphanumeric characters including
hyphens (-) and periods (.).
Note:
• Toenteraservername,itisnecessarytoselect
"Manual" or "Auto" for "DNS".
SMTP port number
Enter a number from 1 - 65535 for the SMTP port num-
ber.
Default: 25
POP server address
Enter an IP address or a name of the POP server to be
used to receive e-mails.
Enter up to 255 alphanumeric characters including
hyphens (-) and periods (.).
Note:
• Toenteraservername,itisnecessarytoselect
"Manual" or "Auto" for "DNS".
Authentication
Type
Select the authentication type to send e-mails from the
following.
None (default)/POP before SMTP/SMTP
Setup items
Zobrazit stránku 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 109 110

Komentáře k této Příručce

Žádné komentáře